Connect this module to your Banshee via I2C to read and write to HF/LF devices.
The module supports SPI I2C and UART connection. The corresponding connection type can be set via 2 DIP switches.
Set to I2C for Banshee use.
The PN532 supports 4 different operating modes:-Reader/writer mode supporting ISO 14443A / MIFARE® and FeliCa™ scheme
-ISO 14443B in reader/writer mode only
-Card interface mode supporting ISO 14443A / MIFARE® and FeliCa™ scheme
-NFCIP-1 mode
Technical data:-Operating voltage: 3.3V-5V
-Current consumption during operation: 13-26mA / peak: <30mA
-Current consumption in standby: 10-13mA
-Operating frequency: 13.56 MHz
-Card reading distance: 0 - 60mm
-Communication: SPI, I2C, UART (adjustable via DIP switch)
-Data transmission frequency: Max. 10 Mbit / s
-Dimensions: 40 x 60 mm
-Operating temperature: -20 ~ 80°C
-Comes pre-soldered with 4pins to fit the Banshee
Included:
- 1x RFID module PN532
- 1x blank standard card
- 1x transponder in the form of a key fob
- 2x pin header (1x straight, 1x 90° angled)
RFID/NFC Module PN532
- Do not expose to direct heat, moisture or strong magnetic fields.
- Avoid electrostatic discharges to protect components from damage.
- Do not overstress the modules mechanically (e.g. bending, crushing).
- Always observe the correct voltages and pin assignment when connecting.
- Only install and operate in well-ventilated areas.
- Protect the module from unauthorised access to prevent tampering.
